Features
1. Fully automatic transmission of products, the front can be connected to the automatic plug-in line, and the back can be connected to wave soldering. The outlet is equipped with photoelectric sensors. The machine stops running when the product arrives at the outlet, and resumes work after taking it away. It is convenient for manual immersion tin operation, and the effect is better when used with an automatic tin immersion machine. This product is also equipped with an exhaust hood, which can be directly connected to the exhaust pipe and can be used. It can better remove the odor of the flux. It is more comfortable for employees to operate. It will not worry about the smell of the flux, and it is more conducive to improving the quality of the production workshop. surroundings.
2. The open design of the automatic flux sprayer makes it easier to observe the working condition and spraying effect of the machine, and is convenient for maintenance and cleaning. It adopts the combined control of touch screen and PLC to spray the flux intelligently. When the product is sprayed on the nozzle above the nozzle, the spray will stop when the product leaves above the nozzle, and the stroke of the nozzle swinging back and forth will be automatically adjusted according to the width of the product. Compared with the traditional spraying method, more than half of the flux is saved, and the board surface is clean after the product is welded, which truly achieves the effect of no-clean board.
Techinical parameters
No. |
Item |
Parameters |
1 |
Transport direction |
Left→right (can be customized, right→left) |
2 |
Host control method |
Display control touch screen + Mitsubishi PLC |
3 |
Flux capacity |
Max5.2L |
4 |
Spray method |
Stepping motor + ST-6 nozzle scanning spray |
5 |
Power supply |
3-phase 5-wire system 220V 50HZ |
6 |
Gas source |
4-7KG/CM2 12.5L/Min |
7 |
Overall dimensions |
1500*600*1180mm |
8 |
Nozzle adopts |
ST-6 |
9 |
Spray range |
20-400mm adjustable |
10 |
Nozzle height |
50-200mm adjustable |
11 |
Pneumatic system |
Inlet filter, control valve and pipe joint |
12 |
Spray nozzle moving system |
Stepper motor drive, Mitsubishi PLC |
13 |
Nozzle movement method |
Stepping motor circuit board heating device |
14 |
Extended preheating zone |
500mm |
15 |
Temperature control range |
200 degrees |
16 |
Temperature control |
PID control |
17 |
Heating parts |
Taiwan Exhibition high temperature heating wire + hot air motor |
18 |
Installation mode |
Drawer type modular heating tube |
19 |
PCB transfer system rail parallelism |
0.5mm |
20 |
Widen |
Hand crank |
21 |
Transmission speed setting unit range |
1mm/min 0-2200mm/min |
22 |
Transmission speed deviation range electronic |
Closed loop control within 0-10mm/min |
23 |
Transport motor |
Taiwan TCG 40W 50K geared motor |
24 |
Body structure |
Cold plate paint shell with exhaust hood |
25 |
Electrical and control performance |
Touch screen interface + instrument |